Fittings Knees, tees, collars, etc.

The welded seat is designed for the installation of additional branches of the polypropylene pipeline.

The 45° elbow is designed to change the direction of the pipeline by 45 degrees.

The 45° inner/outer elbow is designed to change the direction of the pipeline from the fitting.

The 90° elbow is designed to change the direction of the pipeline by 90 degrees.

The 90° inner/outer elbow is designed to change the direction of the pipeline from the fitting.

The 90° transition elbow is designed to change the direction of the pipeline with a change in diameter.

The 90° transition elbow with a plastic external thread is designed to change the direction of the pipeline from the fitting with a transition to a plastic threaded connection.

The polypropylene collector is designed for parallel connection to the main (supply) pipe of several outlets and equalization of pressure to consumers: water pipes, appliances, etc.

The crosspiece is designed to connect four pipes of the same diameter at the point of their divergence into different flows.

The collector plug with an air vent is designed for temporary or permanent blocking of the outlets, both the collector and the end pipelines with the possibility of removing accumulated gases and air.

The threaded plug is intended for the end element of the pipeline with an internal thread as a temporary plug. It has a hexagonal body for a wrench.

The plug is designed to close the (permanent or temporary) polypropylene bell.

The internal plug is designed for permanent closure of the socket of polypropylene fittings, including for the distribution manifold and distribution unit.

The distribution unit with internal plugs is designed for the distribution of multidirectional and multi-temperature water/coolant flows, allows you to mount cross flows in one node.

The tee is designed for mounting a branch from the pipeline main line without changing the diameter.

The transition tee is designed for mounting a branch from the pipeline trunk with a transition to a smaller diameter.

The corner tee is designed to branch off from the pipeline at an angle of 90 °.

The fitting collar is designed for the device of detachable flange connections of pipelines.

The flange collar is designed for the device of detachable flange connections of pipelines.

The flange collar-coupling is designed for the device of detachable flange connections of pipelines without an additional coupling.

The crossing is intended for the correct implementation of the crossing of pipeline routes.

The bell-shaped crossing is intended for the correct implementation of the crossing of pipeline routes. The fitting is equipped with sockets.

The compensating loop is designed to compensate for linear extensions of the pipeline.

The coupling is designed to connect the pipeline.

The adapter coupling is designed to change the diameter of the pipeline.

The adapter coupling (internal/ external) is designed to change the diameter of the pipeline.

• Pipe installation guide.